Toshiba EO1-33057 Parameter Setting Cont, Pre-Strip Selection, Reverse Feed Speed Selection

2. PRINTER SETUP

ENGLISH VERSION EO1-33057

2.8 Setting an Operating Environment

2.8.1Parameter Setting (Cont.)

(26) Pre-Strip Selection

This parameter is to choose whether to activate the Pre Strip function. When this parameter is set to ON (Available), the top edge of a label is separated (pre-stripped) from the backing paper before the label is printed. This function is intended to make the strip issue easier in case the labels are hard to strip due to the label intensity, adhesive power, or the printing speed.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET PRE PEEL OFF OFF

This parameter is fixed to OFF.

Press the [PAUSE] key.

(27) Reverse Feed Speed Selection

This parameter is to choose a reverse feed speed.

In the strip issue, the back feed speed of 3”/sec. may cause a shortage of feed amount due to a lack of torque, slippery media surface, etc. In such case, reduce the back feed speed to 2”/sec. to secure the feed amount.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET BACK SPEED STD

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

BACK SPEED STD

BACK SPEED LOW

STD: 3 inch/second

LOW: 2 inch/second

After selecting the Back Feed Speed, press the [PAUSE] key.

E2-34