Toshiba EO1-33057D Parameter Setting Cont, Auto Print Head Check Selection, and a release of

2. PRINTER SETUP

ENGLISH VERSION EO1-33057

2.8 Setting an Operating Environment

2.8.1Parameter Setting (Cont.)

NOTES:

1.It is recommended that this function should be activated when high quality printing such as bar codes printing is required. Otherwise, choose OFF.

2.When a broken element is found, the printer stops, displaying “HEAD ERROR”. The error state can be cleared by pressing the [RESTART] key, but if the broken element affects bar code readability or actual operations, please replace the print head with a proper one.

(18) Auto Print Head Check Selection

This parameter is to choose whether to perform the Auto Print Head Check function at the power on time. When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET AUTO HD CHK OFF

Use the [FEED] or [RESTART] key to select a desired option.

		AUTO HD CHK OFF
[RESTART]
		Auto print head broken element
		check is not performed.
	[FEED]
		AUTO HD CHK ON

Auto print head broken element check is performed.

After selecting auto print head check, press the [PAUSE] key.

(19) Centronics Interface ACK/BUSY Timing Selection

This parameter is to choose an ACK/BUSY timing of the Centronics interface.

“TYPE1” has been chosen as default, but if a communication error occurs or a communication is not properly made, change to “TYPE2”.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears”.

<2>PARAMETER SET ACK/BUSY TYPE1

Use the [FEED] or [RESTART] key to select a desired option.

		ACK/BUSY TYPE1
[RESTART]			and a release of
		A rise of ACK signal
		BUSY occur at the same time.
	[FEED]
		ACK/BUSY TYPE2

A fall of ACK signal and a release of

BUSY occur at the same time.

After selecting an ACK/BUSY timing, press the [PAUSE] key.

E2-30