Toshiba EO1-33057D Dump Mode Setting, After selecting the receive buffer, press the Pause key

2. PRINTER SETUP

ENGLISH VERSION EO1-33057

2.8 Setting an Operating Environment

2.8.2 Dump Mode Setting

NOTES:

While “<4>DUMP MODE” is displayed on the LCD Message Display, press the [PAUSE] key to enter the Dump Mode.

In the Dump Mode, data in the receive buffer are printed. Data are expressed in hexadecimal values. This operation allows the user to verify programming commands or debug the program.

When “<4>DUMP MODE” appears, press the [PAUSE] key.

<4>DUMP MODE BUFFER RS-232C

Use the [FEED] or [RESTART] key to choose a receive buffer to be dumped.

		BUFFER	RS-232C
		BUFFER	CENTRO.
[RESTART]
		BUFFER	NETWORK
		BUFFER	BASIC 1
		BASIC Interpreter (Interface → Interpreter buffer)
	[FEED]
		BUFFER	BASIC 2
		BASIC Interpreter (Interpreter → Printer buffer)
		BUFFER	USB

After selecting the receive buffer, press the [PAUSE] key.

<4>DUMP MODE PRINT ON DEMAND

Use the [FEED] or [RESTART] key to select a printing method.

1.When “ON DEMAND” is selected, it is required to choose a printing method again and press the [PAUSE] key to print the

subsequent data until the all data has been printed.

2 If an error occurs during

dumping, the printer will display

[RESTART]

[FEED]

PRINT ON DEMAND

Prints 166 lines of data (approx. 50cm), then stops.

*To print the subsequent data, choose a printing method again and press the [PAUSE] key.

PRINT ALL

an error message and stop

printing. The error can be

cleared by pressing the [PAUSE]

key, and then the display will

show “<4>DUMP MODE”

again.

After a recovery from the error

the printer will not start printing

automatically.

Prints all data in the receive buffer, then stops.

After selecting a printing method, press the [PAUSE] key.

<4>DUMP MODE

NOW PRINTING...

[PAUSE]

<4>DUMP MODE

Turn off the power, and then on.

ON LINE

B-SX8T Vx.x

E2-36