Toshiba FS-2600-1 owner manual Read and Reset Reports, Terminal Reports, In-line Reports

2. READ AND RESET REPORTS

EO1-11138

2.1 Terminal Reports

2.READ AND RESET REPORTS

2.1Terminal Reports

Since most reports are taken as in-line reports on the Master Terminal, some of the reports which are available on the individual standalone ECR basis cannot be taken on Master or Satellite ECRs of the in-line system. The following are the reports which are listed in the MANAGER’S GUIDE for the standalone level but cannot be taken on any ECRs of the in-line system. Other reports not listed below can be taken even in the in-line system. (Before taking those reports, however, please read the next section 2.2: In-line Reports.)

TERMINAL REPORTS that cannot be taken on any ECRs of the in-line system

DAILY REPORTS

REPORT NAME

CASHIER READ AND RESET REPORTS (when adopting the Floating Cashier Feature)

•Individual Cashier Read

•Individual Cashier Reset

•All Cashier Read

•All Cashier Reset

CHECK TRACK (Guest Order Table) WITH SALES READ AND RESET REPORTS

•Individual Cashier Read

•Individual Cashier Reset

•All Cashier Read

•All Cashier Reset

CHECK TRACK (Guest Order Table) WITHOUT SALES READ REPORTS

•Individual Cashier

•All Cashier

EMPLOYEE CLOCK-IN/CLOCK-OUT READ AND RESET REPORTS (Daily and Weekly)

GT REPORTS

REPORT NAME

CASHIER GT READ AND RESET REPORTS (when adopting the Floating Cashier Feature)

•Individual Cashier GT Read

•Individual Cashier GT Reset

•All Cashier GT Read

•All Cashier GT Reset

EMPLOYEE CLOCK-IN/CLOCK-OUT GT READ AND RESET REPORTS

2.2In-line Reports

2.2.1In-line Report Command Executions

Before taking in-line reports, please note the following:

1)In-line Reset Reports (as well as In-line Read Reports) can be taken on the Master Terminal as long as the Satellite Terminals are in the idle status (“Signed OFF”condition in case of the cashier code entry type). To check status of all the terminals connected to the in-line loop, Terminal Condition Check can be operated (refer to Chapter 1).

2)When In-line Reports are taken, the power of each Satellite terminal must be turned ON but the Mode Lock can be in any position.

The operation flow for taking In-line Reports is shown on the next page, and the table of In-line Reports is on the following pages.

2-1