Toshiba FS-2600-1 Other Operations Relating to IN-LINE Service, Suspending, Retry, Cancel

11. OTHER OPERATIONS RELATING TO IN-LINE SERVICE EO1-11138

11.1 Suspending

11. OTHER OPERATIONS RELATING TO IN-LINE SERVICE

The following are other operations relating to in-line service operations.

11.1Suspending

This is to be operated for the purpose of suspending an in-line service being executed, when any terminals remain unserviced, and of going on to a “RETRY”, “INCOMPLETE ENDING”, or “CANCEL” operation as the next step. OPERATION ON MASTER TERMINAL: (Same Lock positions as the in-line job being performed)

Depress [ITEM CORR] until the key-in tone is generated.

DESCRIPTION:

The SUSPENDING operation is allowed any time during an in-line service procedure.

If suspending by the [ITEM CORR] key is accepted, the Master terminal’s display indicates the number of unserviced terminals. (SUSPENDING of a service execution of one terminal is not possible). Now a “RETRY” or “INCOMPLETE ENDING” operation can be selected as the next step. (When no key-in operations are made in about 10 seconds after a SUSPENDING operation, a RETRY process will automatically be executed.)

11.2Retry

This is to be operated for the purpose of re-attempting the in-line service that has been stopped due to “TIME OUT” or that has just been suspended by “SUSPENDING” operation.

OPERATION ON MASTER TERMINAL: (Same Lock positions as the in-line job being performed) Depress [AT/TL].

DESCRIPTION:

The in-line service will again be attempted to the unserviced terminals. This operation is possible any number of times after a “TIME OUT” condition or a “SUSPENDING” operation as long as any terminals remain unserviced. (When no key-in operations are made in about 10 seconds after a SUSPENDING operation, a RETRY process will automatically be executed.)

11.3Incomplete Ending

This is to be operated to abandon services to unserviced terminals, and ends the in-line service with the services to service-completed terminals only.

OPERATION MASTER TERMINAL: (Same Lock positions as the in-line job being performed) Depress [NS].

DESCRIPTION:

If an in-line service being executed does not seem to end normally due perhaps to some abnormal status of any Satellite Terminals after “TIME OUT”, “SUSPENDING”, and/or “RETRY” operations, the [NS] key can be depressed to end the in-line service with only the service-completed terminals serviced and the unserviced terminals remaining unserviced. In case of In-line X or Z Report Collection sequences, reports of only the service-completed terminals will be issued.

11.4Cancel

This can be operated when a SUSPENDING condition arises due to a TIME OUT or a SUSPENDING operation. The entire in-line service being performed is canceled. This operation is effective to in-line read report operations but not to any in-line reset report operations.

OPERATION MASTER TERMINAL: (Mode Lock: X)

Depress [X].

11-1