Configuring a NetWare 5.x Server with NDPS

The following procedure assumes NDPS has been installed during NetWare 5 installation and that a Broker is running on the server. Unless you have manually unloaded the Broker, it loads and runs when you install NDPS. Make sure you are using NetWare 5.x Service Pack version 3.0 or later, and the Novell Gateway version 2.0.3 or later. Finally, create an NDPS Manager. For more information, see your NetWare documentation.

Also In GA-1140 Setup, make sure you have enabled TCP/IP on the GA-1140.

Depending on the security needs at your organization, you can set up the GA-1140 as a Public Access printer or a Controlled Access printer. The following procedure describes setting up a Public Access printer. You can then convert this type of printer to Controlled Access if necessary. For more information, see your NetWare documentation.

1.In NetWare Administrator, double-click the NDPS Manager object you have created.

2.In the Details window for the NDPS Manager object, click the Printer Agent List button.

The list of Printer Agents appears.

3.Click New.

The Create Printer Agent dialog box appears.

4.In the Printer Agent (PA) Name field, enter a name.

5.Under Gateway Types, select Novell Printer Gateway, and click OK.

6.In the Configure Novell PDS for Printer Agent dialog box, select “((NONE))”, and click OK.

7.In the Configure Port Handler dialog box, choose “Remote LPR on IP” as the connection type, and click Next.

8.For Host Address, enter the IP address of the GA-1140.

9.For Printer Name, enter the name of the GA-1140 print connection you want users to print to, and click Finish.

This name must be print or hold.

10.In the Select Printer Drivers dialog box, select the printer driver for Windows 95/98/Me/2000 and the driver for Windows NT 4.0.

11.Click Continue, and click OK.

34

Page 36
Image 36
Toshiba GA-1140 manual Configuring a NetWare 5.x Server with Ndps