Toshiba MA-1595-1 Programming Operations Common with Standalone ECR Level, Programming JOB List

5. PROGRAMMING OPERATIONS EO1-11152

5.1 Programming Operations Common with Standalone ECR Level

5.PROGRAMMING OPERATIONS

The system should be programmed fully by your local TOSHIBA TEC representative at the time of delivery according to the user’s requirements so that daily operations can immediately start. However, some data must be added or changed daily or in a longer period. Since the volume of programming contents for the system is too large, this chapter and the following two chapters are provided as guide lines of the user’s daily programming and maintenance operations. If there are any unclear points or program data other than listed here must be changed or added, please contact your TOSHIBA TEC representative. Please also note that some programming operations introduced in the Standalone Level are modified or not available on in-line terminals.

5.1 Programming Operations Common with Standalone ECR Level

The following is the table of programming operations which are introduced in the Manager’s Guide for the Standalone Level and can be operated on in-line terminals as well, with the Submode No. and operation sequence unchanged. However, on in-line terminals, these are usually operated on the Master Terminal only and down-line-loaded (DLLed) to all the Satellite Terminals. Therefore, if any program data is changed, a DLL is further necessary to load the new data (after the change) to all the Satellite Terminals (to be described in Chapter 6).

PROGRAMMING JOB LIST

Master*1: Programming job to be available when the [RTR] key is activated on the Master Terminal

Satellite*2: Programming job to be available on the Backup Master Terminal and the Satellite Terminal when the [RTR] key is off on the Master Terminal

			O: Available
Submode	Programming Job	Terminals
No.		Master*1	Satellite*2
1	Store Name Message, Commercial Message, and Footer Logo Message	O	O
	Programming
2	Cashier Code and Name Programming	O
3	Department Table Programming	O
4	PLU Table Programming	O
5	Time Setting or Adjustment	O	O
6	Date Setting or Adjustment	O	O
8	Amount Limit Setting for Function Keys	O	O
15	Customer File Code (Check Track No.) and Name Programming	O
20	Salesperson Code and Name Programming	O
25	Link PLU Table Programming	O
26	Tare Table and General Unit Weight Setting	O
27	PLU Preset-code Key Setting	O	O
31	Display Message Programming	O	O
35	Negative Amount Key Limit Amount Setting	O
40	PLU Price Dollar Discount/Extra Charge Amount Setting	O
No	Department Preset Price Setting or Changing	O
Submode	PLU Preset Price Setting or Changing,	O
	Whole Package Quantity Changing
	%+ and %- Preset Rate Setting	O	O
	Preset Rate Setting for Selective Itemizers	O	O
	Foreign Currency Exchange Rate Setting	O
	Tax Table Programming	O
	Store/Register No. Setting	O	O

5- 1