6. TERMINAL FILE PROGRAMMING
EO3-11106
6.19 Department Table Programming
6-100
*5: High Amount Limit
• Enter a maximum of 7 digits to be set as the high amount to be locked out.
Example) To prohibit any amount equal to or larger than 40,00:
4000 [Enter]
(Allows any amount equal to or smaller than 39,99.)
NOTES:
1. To cancel the preset limit (i.e. to allow any amount), input 0.
2. The limit amount set here will be applied to entries in REG mode only, but not in MGR or - mode.
3. Zeros must be entered as all the digits other than the highest digit. If any other value is entered, it will be
regarded as a zero.
Example) Entering 4001 to 4999 will all result in setting 4000.
*6: Low Amount Limit
• Enter a maximum of 7 digits to be set as the low amount limit.
Example) To prohibit any amount smaller than 4,00:
400 [Enter]
(Prohibits any amount smaller than 4,00.)
NOTES:
1. To cancel the preset limit (i.e. to allow any amount), input 0.
2. The limit amount set here will be applied to entries in REG mode only, but not in MGR or - mode.
3. Zeros must be entered as all the digits other than the highest digit. If any other value is entered, it will be
regarded as a zero.
Example) Entering 401 to 499 will all result in setting 400.
*7: Gross Profit Rate
• Enter the gross profit rate of the department in a maximum of 3 integer digits and 2 decimal digits.
[Enter] or [ • ] [Enter]
0 to 100 (%) 0,01 to 99,99 (%)
• The calculated gross profit will be outputted to the DEPARTMENT GROSS PROFIT REPORT.
• The fraction resulted from the profit calculation will be discarded.
• To cancel the gross profit rate once set, input 0 in place of a specific rate before [Enter]. The
department whose gross profit rate has thus been cancelled will not be outputted in the GROSS PROFIT
REPORT.
3) Example
To program the following Department Data
Department Code: 01
Department Group No.: 01
Preset Price: Open
Department Status: Single-item
Tax Status: VAT 1 and VAT 2
HALO: €40,00
LALO: €4,00
Gross Profit Rate: 10,00%
Operation LCD Display Remarks
When the ECR is being outside a sale
and in SET mode, depress the [↓] key
twice.
The cursor is moved on to “3 DP/PLU”.
(continued on the next page)