Toshiba MA-600 manual Drawer Close, Compulsory, Drawer Warning Alarm, Single-drawer or Multi

6. TERMINAL FILE PROGRAMMING

EO3-11106 6.5 System Option Programming

					System Option Table
							Standard Bit Set (auto-set by RAM Clear)
ADDRESS NO.			CONTENTS							1
	27		DRAWER OPTION
BIT		ITEM		SELECTIVE STATUS			STANDARD		REMARKS
NO.							STATUS
1		Drawer Close	RESET		NOT COMPULSORY			NOTE 1 below
		Compulsory	SET		COMPULSORY	*
2		Drawer Warning Alarm	RESET		NON-ACTIVE	*		NOTE 2 below
			SET		ACTIVE
3		Single-drawer or Multi-	RESET		SINGLE DRAWER	*		NOTE 3 below
		drawer	SET		MULTI DRAWER
4		Multi-drawer Control	RESET		BY CASHIER	*
			SET		BY CURRENCY
5		Selection of Change at	RESET		IN DOMESTIC CURRENCY	*
		Tendering in Foreign						NOTE 4 below
		Currencies	SET		IN FOREIGN CURRENCY
6		Number of Drawers	RESET		1 DRAWER	*
		(if Multi-drawer spec.)	SET		2 DRAWERS
7		-- vacant --	RESET			*
			SET
8		-- vacant --	RESET			*
			SET

NOTE 1: If SET, the Drawer-close Compulsory option is active. In this case, when the drawer remains open, any operations except [RF], [JF], [C], numeric input for Sign-ON are prohibited. This rule is applied in REG, MGR, - , and LOCK modes; in the other modes, the drawer may remain open.

NOTE 2: This bit status selection is effective only when Bit No. 1 is SET. If SET (ACTIVE), the setting in the DRAWER WARNING TIME operation will be effective. In this operation, a time value in seconds can be set for the time length with the drawer open until the warning alarm generated (the initial value is 15 seconds).

NOTE 3: If SET, the Multi-drawer specification is selected.

In the case of Cashier Code Entry Method (using [LOG] or [LOG/RECEIPT] key), a drawer is to be designated in sale entries, and the number of drawers will be further selected at Bit No. 6.

In the case of Cashier Key Method, the drawer to be used will be fixed as in the following: Drawer 1 for Cashier 1, Drawer 2 for Cashier 2 & all others.

NOTE 4: This bit status selection is available regardless of the status selection for the bit No. 3 and the bit No. 4 in this address. If RESET, change is returned to a customer by the domestic currency in the foreign currency tendering operation.

If SET, change is returned to a customer by the foreign currency, the symbol “ ” is displayed in the leftmost 2 digits on the 7-segment Numeric display.

•When change is returned to a customer by the foreign currency, the symbol “ ” will always be displayed even if the option of the cashier No. display or the PLU price level display (Bits No. 5 and No. 6 of Address No. 4) has been selected.

•When change is returned to a customer by the foreign currency, the Drawer 2 will open if both the bit No. 3 and the bit No. 4 in this address have been “SET”.

6-34