4.29 Fluorescent Lamp 4 Replacement Procedure
Setting the bezel
1. Put the bezel on the top of the frame and latch at four points. ((1) in the bellow
figure)
2. Put the bezel on the bottom of the frame and latch at three points. ((2) in the bellow
figure)
3. Hold the bottom side lightly and stick a double-side tape.
CAUTION: Be careful not to damage the cell, TAB and B/L.
The reflector shall not
come out of the bezel.
The reflector shall not
come out of the bezel.
Latch at four
points
Latch at three point.
Double-sided tape inside of
the bottom of the bezel
Figure 4-57 Replacing TMD fluorescent lamp (9)
PORTÉGÉ M500 Maintenance Manual (960-559) [CONFIDENTIAL] 4-83