Toshiba RAV-SM2802DT-TR Applicable Controls, nRemote Controller Wiring, Wiring diagram, Procedure

Concealed Duct High Static Pressure

Group control

(Unit: mm)

Installation Manual

Wired remote controller

Concealed Duct High Static Pressure Installation Manual

9 APPLICABLE CONTROLS

10	10
	R (L) S (N)
30	40

Indoor fan power supply wire

A B	A B
Indoor Unit	Indoor Unit

Outdoor Unit Outdoor Unit

REQUIREMENT

•When you use this air conditioner for the first time, it takes approx. 5 minutes until the remote controller becomes available after power-on. This is normal.

<When power is turned on for the first time after installation>

It takes approx. 5 minutes until the remote controller becomes available.

		Approx. 5 minutes
Power on	“SETTING”	“SETTING”	Remote
			controller
	flashes	goes out	is available

Procedure 1

Push button and TEMP. button simultaneously for at least 4 seconds.

After a while, the display flashes as shown in the figure. Confirm that the CODE No. is [01].

•If the CODE No. is not [01], push button to erase the display content, and repeat the procedure from the beginning. (No operation of the remote controller is accepted for a while after button is pushed.)

(∗ Display content varies

1	2	3	10
10
30			40

–95System interconnecting wire –

nRemote Controller Wiring

•Strip off approx. 9mm the wire to be connected.

•Non polarity, 2 core wire is used for wiring of the remote controller. (0.5mm² to 2.0mm² wires)

<When power is turned on for the second (or later) time>

It takes approx. 1 minute until the remote controller becomes available.

		Approx. 1 minute
Power on	“SETTING”	“SETTING”	Remote
			controller
	flashes	goes out	is available

•Normal settings were made when the indoor unit was shipped from factory.

Change the indoor unit settings as required.

•Use the wired remote controller to change the settings.

*The settings cannot be changed using the wireless remote controller, sub remote controller, or remote controller-less system (for central remote controller only).

Therefore, install the wired remote controller to change the settings.

with the indoor unit model.)

Procedure 2

Each time you push button, indoor unit numbers in the control group change cyclically.

Select the indoor unit you want to change settings for. The fan of the selected unit runs.

You can confirm the indoor unit for which you want to change settings.

Procedure 3

Using TEMP. / buttons, specify CODE No. [✻✻].

Wiring diagram

Terminal block for	Terminal block
remote controller wiring of indoor unit
A	A	Remote controller unit
B	B

Remote controller wire (Locally procured)

nChanging of setting applicable control

Basic procedure for changing settings

Change the settings while the air conditioner is not working. (Be sure to stop the air conditioner before making settings.)

4	1
	3

6

Procedure 4

Using TIME / buttons, select SET DATA

[✻✻✻✻].

Procedure 5

Push button. When the display changes from flashing to lit, the setup is completed.

•To change settings of another indoor unit, repeat from Procedure 2.

•To change other settings of the selected indoor unit, repeat from Procedure 3.

Use button to clear the settings.

To make settings after button was pushed, repeat from Procedure 2.

1 5 2

– 27 – – 28 –