Notes for use of this device in New Zealand
❑The grant of a Telepermit for a device in no way indicates Telecom acceptance of responsibility for the correct operation of that device under all operating conditions. In particular the higher speeds at which this modem is capable of operating depend on a specific network implementation which is only one of many ways of delivering high quality voice telephony to customers. Failure to operate should not be reported as a fault to Telecom.
❑In addition to satisfactory line conditions a modem can only work properly if:
a/ | it is compatible with the modem at the other end of the call and |
b/ | the application using the modem is compatible with the application at the |
| other end of the call - e.g., accessing the Internet requires suitable |
| software in addition to a modem. |
❑This equipment shall not be used in any manner which could constitute a nuisance to other Telecom customers.
❑Some parameters required for compliance with Telecom’s PTC Specifications are dependent on the equipment (PC) associated with this modem. The associated equipment shall be set to operate within the following limits for compliancewithTelecomSpecifications:
a/ | There shall be no more than 10 call attempts to the same number within |
| any 30 minute period for any single manual call initiation, and |
b/ | The equipment shall go |
| between the end of one attempt and the beginning of the next. |
c/ | Automatic calls to different numbers shall be not less than 5 seconds |
| apart. |
❑Immediately disconnect this equipment should it become physically damaged, and arrange for its disposal or repair.
❑The correct settings for use with this modem in New Zealand are as follows: ATB0(CCITToperation)
AT&G2(1800Hzguardtone)
ATS6=4(Blinddialdelay)
ATS7=less than 90 (Time to wait to carrier after dialing)
ATS10=less than 150 (loss of carrier to hangup delay, factory default of 15 recommended)
