TROUBLESHOOTING
User's Manual
| You can also use the ATX command. Refer to the |
| online help files for Appendix C, AT Commands. |
|
|
You place a call, | Make sure the settings are correct in your |
but a connection | communications application. |
can’t be made |
|
|
|
After making a call | Make sure the tone or pulse selection in your |
you can’t hear a ring | communications application is set correctly. |
| You can also use the ATD command. Refer to |
| the online help files for Appendix C, AT Com- |
| mands. |
|
|
Communication is | The computer will automatically cut off |
cut off unexpectedly | communication when connection with the carrier |
| is not successful for a set time interval. Try |
| lengthening this time interval. |
|
|
A CONNECT display | Check the error control setting in your |
is quickly replaced by | communications application. |
NO CARRIER |
|
| You can also use the AT\N command. Refer to |
| the online help files for Appendix C, AT Com- |
| mands. |
|
|
Character display | In data transmission, make sure the parity bit |
becomes garbled | and stop bit settings correspond with those |
during a | of the remote computer. |
communication | Check the flow control and communication |
| |
| protocol. |
|
|
You cannot receive | Check the rings before auto answer setting in |
an incoming call | your communications application. |
