®
Chapter 4
Main module mounting
After mounting and wiring the termination module, attach the main module to the termination module. This chapter provides information and procedures that enable you to mount the main module.
Note:
The Tracker controller ships with the display module assembled to the main module. If those two modules are assembled, performing this procedure also mounts the display module.
Note:
It is not necessary to turn off 24 Vac power to the Tracker controller prior to mounting or removing the main module.
1.Verify that all wires on the termination module are securely fastened in place.
2.Carefully line up the alignment pins on the termination module with the back side of the main module (Figure 21 on page 42).
CAUTION
Avoid Equipment Damage!
Do not use excessive force when mounting the module. If the module does not snap easily into place, slightly reposition it on the alignment pins. Failure to comply may cause damage to the module.
3.Firmly push the main module onto the termination module until it snaps into place. If 24 Vac power is applied, the main module will start. If the display module is not assembled to the main module, you will see the LEDs on the main module flash on and off after a few sec- onds. If the display module is assembled to the main module, it will turn on and display information.
| 41 |
