Trane RAUC-C50, RAUC-C30 General Information, Evaporator Nameplate, EVP Chiller Applications Only

General Information

Evaporator Nameplate

(EVP Chiller Applications Only)

The nameplate is located on the same side of the refrigerant connections near the top. To view the nameplate, remove the tape over the area and spread the insulation. Retape the insulation after viewing.

Unit Description

All air cooled condensing units are designed for outdoor installations with vertical air discharge. These units may be installed on a flat roof or placed on a concrete slab at ground level.

Before shipment, each unit is leak-tested, evacuated, a Nitrogen holding charge is added, and the controls are tested for proper operation.

The condenser coils are aluminum fin, bonded to copper tubing. Copper-fin coils are optional. Louvered condenser grilles for coil protection are standard. Direct-drive, vertical discharge condenser fans are provided with built-in current and overload protection.

For “Ship with” items, refer to the Unit Component “Layout” and “Ship with” Locations illustration.

Figure 1. Unit Component Layout and ‘shipwith’ Locations (60 Ton Unit Illustrated)

If low ambient operation is required, low ambient dampers are available as a field or factory installed option.

These units may be order with one of the following options:

No System Controls (Field provided controls required)

Constant Volume Controls

Supply Air Temperature Control (VAV applications)

EVP Chiller Controls

Basic unit components include:

Manifolded Scroll Compressors

Intertwined condenser coils

Condenser fans (number based on unit size)

Discharge service valve (one per circuit)

Liquid line service valve (one per circuit)

6 SS-SVX09A-EN