Configuration: Pump > General

VBStar

Configuration: Pump > General

Click here to examine ...

Click on this link to examine hard drive content. You must know

 

the user name and password to login to the FTP server and view

 

content. You can use any FTP client application to access the

 

hard drive using a URL like this: ftp://admin@<IP_Address>/D:

 

Be sure to login to the D: drive as shown. Do not modify or

 

store files on the C: drive. The C: drive has limited space and is

 

reserved for VBrick firmware.

 

 

Pump Mode

Used to set the stream to be controlled manually or to

 

automatically start at the VBStar Power-Up.

 

 

Pump File Name

This is the file that will "Pump". In batch mode, the Batch Base

 

File Name is usually entered as the Pump File Name, the batch

 

files will be played from the lowest numbered through the

 

highest number. If a batch file name is entered with a particular

 

batch file number, the file will be pumped using that file as the

 

starting point. Any missing files in the series will be skipped and

 

the next sequential file will play.

 

Example: If files test1.mpg through test15.mpg exist and the

 

user specifies test5.mpg, test5.mpg through test15.mpg will be

 

played. After playing test15.mpg, test5.mpg will be played again,

 

even though lower numbers of the file exist.

 

 

IR Enable

Is used to enable or disable the use of IR Controller to "Pump"

 

the specified stream.

 

 

Batch Enable

If enabled, a series of files in a batch will be played sequentially.

 

If disabled, only a single file will be played.

 

 

VBrick MPEG-2 Appliance Admin Guide

101

Page 109
Image 109
VBrick Systems VB4000, VB6000 Configuration Pump General, store files on the C drive. The C drive has limited space and is