VBrick Systems VB6000 Maintenance Mode CLI Operation, Command, Description, Entry, ex or exit

Maintenance Mode

•The Telnet and/or Command Line Interface (CLI) prompt after you login is VBMaintMode> and displays one of t he following codes.

Code 10	Operating system failed to load or the flash is corrupted.
Code 20	Critical system files are missing or corrupted.
Code 30	The Hardware Watchdog has failed.
Code 50	Invalid Flash parameters found, defaults used.
Code 60	Corrupted Bootline, default used.
Code FF	Application failed to start up successfully either because of the
	configuration or another problem. The VBrick appliance will enter
	Maintenance Mode if the appliance does not boot properly on four
	consecutive attempts.

Maintenance Mode CLI Operation

After logging into Maintenance Mode as the Administrator, the VBMainMode> prompt is displayed and one or more of the following command sequences can be issued from the Command Line Interface. By design, in Maintenance Mode, after the user initiates changes and applies, it is necessary to manually save and reboot. For more about the Command Line Interface, see the Network Appliance Installation Guide.

TTo use CLI commands in Maintenance Mode:

1.Make all desired changes, in any sequence, using the commands in Table 6.

2.When done type c nt a to apply the changes.

3.Type sv to save the configuration.

Table 6. CLI Commands

Command	Description	Entry
e 2	To start the editor mode. This	Type e 1 to display editor status.
	command must be entered prior to
	any other command.
ex or exit	To leave the current menu level and
	move up through the menu system.
rb	Reset the VBrick	Enter y (yes to reset).
sd	Set the configuration parameters to	Confirmation is requested.
	factory defaults, except the Ethernet
	IP parameters
sfd	Set the configuration parameters to	Confirmation is requested.
	factory defaults, including the
	Ethernet IP parameters
c nt 5 x	To enable or disable DHCP	1 – Disable DHCP
		2 – Enable DHCP

VBrick MPEG-2 Appliance Admin Guide 97