VBrick Systems VB4000, VB6000, VB5000 manual Status Encoder Status

Source IP Address	The IP Address of the video source.
Bytes Transferred	The number of receive bytes transferred.
Buffer Full Count	The number of times the decoder buffer filled to capacity.
Decoder Sync	Indicates whether the MPEG-2 transport layer has achieved its
State	synchronization. Most likely indicates a configuration or network
	problem.
Lost Sync Count	The number of times the decoder has acquired synchronization with
	the transport stream (see note under Unexpected Fragments).
Packets Received	The count of IP packets received.
Non Video Packet	The count of packets directed to this decoder, which are not part of
	the video stream.
Unexpected	The number of mis-ordered packets received. Each appliance
Fragments	maintains a statistical report on Unexpected Fragments received from
	a particular video stream. Note: If multiple devices in the same unit
	(i.e. decoder or hard disk) are tuned to the same stream, the
	Unexpected Fragments count on Slot1 is used exclusively to report
	statistical results.
Packet Ordering	Packet ordering status. Packet ordering is temporarily disabled under
	conditions, such as the IP ID is not increasing or disabled, or the
	access method does not support reordering. Packets arriving over
	Ethernet can be reordered.
Jitter Queue Status	Status of the jitter Q. It is generally equal to the value of the Jitter
	Queue of the decoder with the following exception: if a variable
	transport (video, audio and idle frames included) rate stream is being
	decoded then the jitter queue will be temporarily disabled. The Jitter
	Queue will be re-enabled when the decoder senses that a video stream
	of fixed rate transport is being received.
Audio Micro-code	Revision of the audio microcode on the decoder chip.
Revision
Video Micro-code	Revision of the video microcode on the decoder chip.
Revision
FPGA Revision	Revision of the FPGA chip on the decoder daughter card.
CPLD Revision	Revision level of the CPLD on the decoder daughter card.
PLX EEPROM	Revision level of the PLX EEPROM on the decoder daughter card.
Revision

Status: Encoder Status

This menu allows users to view vital Encoder statistics. As you Refresh you should see

Transmit State – Transmitting and the IP Bytes Transferred count should increment. If this

does not happen check your VBrick's encoder configuration or network.

68 © 2007 VBrick Systems, Inc.