If SENSe:PERiod:RANGe = 1.0
then settings conflict if 1.0sec < APERture < 4.0sec. If SENSe:PERiod:RANGe = 4.0
then settings conflict if 0.01sec <= APERture < 0.04sec
The E1415/19/22 driver will report these Settings Conflicts at INITiate time with the following error message:
3129, Incompatible Aperture and Range values,SCP[x]
•
•
•
Related Commands: SENSe:PERiod:NPERiods
*RST Condition: is 1
.Send with VXIplug&play Function: hpe14XX_cmd(...)
[SENSe:]PERiod:RANGe[:UPPer]?
[SENSe:]PERiod:RANGe[:UPPer]? <channel> returns the current setting of upper period limit.
Parameters
|
|
|
|
|
|
| Parameter | Parameter | Range of | Default |
|
| Name | Type | Values | Units |
|
|
|
|
|
|
|
| channel | string | 100 - 163 | none |
|
|
|
|
|
|
|
|
|
|
|
|
|
Comments • <channel> must be single channel on an E1538A SCP.
•RETURNS: float32, configured upper period time range for given ch. Response is in seconds. Returned value either 1 or 4
•.Send with VXIplug&play Function: hpe14XX_cmdReal64_Q(...)
[SENSe:]TOTalize:RESet:MODE
[SENSe:]TOTalize:RESet:MODE <select>,<ch_list> sets the mode for
resetting totalizer channels in <ch_list>.
Parameters
|
|
|
|
|
|
| Parameter | Parameter | Range of | Default |
|
| Name | Type | Values | Units |
|
|
|
|
|
|
|
| select | discrete (string) | INIT TRIGger | seconds |
|
|
|
|
|
|
|
| ch_list | string | 100 - 163 | none |
|
|
|
|
|
|
|
|
|
|
|
|
|
Comments • In the INIT mode the total is reset only when the INITiate command is executed. In the TRIGger mode the total is reset every time a new scan
