23 | Programming Light Fixture | |
| ||
| (If Included) | |
|
| |
Tools Needed: | Press the red program button on the light | |
Step Ladder | fixture. The LED on the light fixture will turn | |
on and remain on for 30 seconds | ||
| ||
| or until a opener is learned to the light | |
| fixture. The incandescent lamp will also turn | |
| on when program button is pushed. | |
| Press the light button on the wall station. | |
| This must be done within 30 seconds of | |
| pressing the program button on the light | |
| fixture. The light fixture lamp and LED will | |
| blink three times to indicate successful | |
| programming. The light fixture can now be | |
| turned on and off from this wall station. | |
| NOTE: In order to program the opener to | |
| the light fixture, the installer must have the | |
| wall station already programmed to the | |
| opener. | |
|
|
Program Button 
LED
Light Button
per |
| |
O | at |
|
o | e |
|
T | D |
|
Press |
| |
| o | |
| o | |
| Here | r |
|
| |
24
Tools Needed:
None
Profile Routine
(Standard Upper Limit)
WARNING
TO AVOID INJURY, NO ONE SHOULD CROSS THE PATH OF A MOVING DOOR!
The profile routine automatically sets the door open and close limits and calibrates obstruction sensing. During the profile routine, the door will move up and down twice.
NOTE: If an object such as a ceiling beam obstructs the door from opening completely, skip this step. Set a Custom Upper Limit, see Step 25.
NOTE: The door must be in its fully closed position and the disconnect handle must be in the motor operated position (upper position) to initiate the profile routine.
NOTE: Profile routine will not run if safety sensors are not aligned (only if required installation).
Press and hold the profile button for five (5) seconds. The opener will beep twice, release the profile button, indicating the activation of the profile routine. The door will now move to the fully open position and stop, beep twice and then the door will close completely.
Next, the door will go through one more up/ down cycle. Once this is complete, the door limits are set and the profile is complete.
NOTE: Upon successful completion proceed to Step 26.
Profile Button
28Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.
You can reach us Toll Free at
