8Attaching Disconnect Handle
Tools Needed: | NOTE: The motor must be in the fully down | |
position before setting handle position on | ||
| ||
Phillips | cable. Bring motor to the down position by | |
Head | pulling the disconnect cable while pushing | |
the motor down. Insure opener disconnect | ||
Screwdriver | ||
teeth are engaged before installing | ||
Wire Cutters | disconnect handle. If motor is not fully down | |
when teeth are engaged, turn motor shaft | ||
| ||
Flat Blade | with screwdriver at back of motor counter | |
clockwise until motor is fully down. | ||
Screwdriver | ||
NOTE: Do not use power drill to assemble set | ||
| ||
| screw to handle. | |
| Start the | |
| disconnect handle. Thread the disconnect | |
| cable through the top of the disconnect | |
| handle bracket and then the disconnect | |
| handle. | |
| Locate the disconnect handle in full upper | |
| position of disconnect handle bracket. | |
| Remove all disconnect cable slack between | |
| the opener and the top of the disconnect | |
| handle bracket. Tighten | |
| into the disconnect handle until snug, and | |
| then tighten screw an additional 1 to | |
| turns to secure disconnect cable to the | |
| disconnect handle. Trim off excess cable | |
| from bottom of the disconnect handle. | |
| CAUTION: PULL CABLE ONLY TAUT ENOUGH | |
| TO REMOVE THE CABLE SLACK. PULLING | |
| THE CABLE MORE COULD CAUSE OPENER | |
| TO DISCONNECT FROM THE TORQUE TUBE | |
| AND CAUSE FAILURE OF THE DISCONNECT. |
Upper
Position
Screw
Disconnect
Handle
Disconnect 
Cable
Disconnect
Handle
Bracket
®INSTALLATION TORQUEMASTER
9
Tools Needed:
None
Disconnect Handle Usage
Apply emergency disconnect label next to the mounted bracket. Use mechanical fasteners if adhesive will not adhere.
Using the emergency disconnect, pull down on disconnect handle and place it in the manual door operated position (use disconnect label for reference). Motor will be rotated 90° from its packaged position.
If motor does not pivot 90°, see troubleshooting section in this manual.
Manual operated position
Motor operated position
Emergency
Disconnect
Label
®FOR IDRIVE
Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need. 15 You can reach us Toll Free at
