Xerox 495 manual Code Display Message Procedure

ERROR CODESPROBLEM SOLVING

Code	Display Message		Procedure
0A-01	Cleaner blade A missing	1.	Cleaner blade A has not been installed (see "Replacing the
			cleaner brush and blade" on page 8-18).
		2.	Press RESET on the touch screen.
0A-02	Cleaner blade B missing	1.	Cleaner blade B has not been installed (see "Replacing the
			cleaner brush and blade" on page 8-18).
		2.	Press RESET on the touch screen.
0A-03	Kit A[R3a] end of life	If you would like to change this consumable now then go to the
		Consumables view and press the Change button to replace kit
		A[R3a].
0A-04	Kit B[R3b] end of life	If you would like to change this consumable now then go to the
		Consumables view and press the Change button to replace kit
		B[R3b].
0B-01	Smoke filter end of life	If you would like to change this consumable now then go to the
		Consumables view and press the Change button to replace the
		smoke filter.
0D-02	Splice guide pins held up	The splice guide pins need to be lowered.
		1.	Lower the splice guide lever.
		2.	Press RESET on the touch screen and then set the printer to
			ready.
0D-03	Splice guide pins held up (during	The splice guide pins need to be lowered and the paper realigned.
	printing or emergency stop)	1.	Lower the splice guide lever.
		2.	Press RESET on the touch screen.
		3.	Press FOLD-OUT/-IN on the autoload panel to select the
			correct paper fold.
		4.	Press RESET on the touch screen and then set the printer to
			ready.
0D-04	Paper not loaded	1.	Open the right stacker door.
		2.	Empty the stacker table.
		3.	Press AUTO on the stacker panel to raise the stacker table to
			the printing position.
		4.	Close the right stacker door.
		5.	Press RESET on the touch screen.
		6.	Load the paper automatically (see "Paper autoloading" on page
			5-4).
		7.	Press RESET on the touch screen and set the printer to ready.
0D-06	Fold-out/-in check	The paper perforation needs to be realigned (see "Setting the perfo-
		ration position" on page 5-9).
0D-07	Paper already loaded	There was already paper in the printer when the LOAD switch was
		pressed.
		1.	Remove the paper from the printer (see "Removing Paper" on
			page 5-12).
		2.	Reload the paper (see "Paper Loading" on page 5-3) or press
			FORWARD/REVERSE on the autoload panel, to correct the
			paper alignment.
		3.	Press FOLD-OUT/-IN on the autoload panel to select the
			correct paper fold.
		4.	Press RESET on the touch screen and then set the printer to
			ready.

Page 9-22 Xerox 495 Continuous Feed Duplex Printer Operator Guide