Xerox 495 manual Bubble menu possibilities, Start / Stop Print Position Check procedure is

RUNNING JOBS RUNNING PRODUCTION JOBS

Bubble menu possibilities

Bubble menu command buttons depend on the exact equipment in the print line. The following bubble menu command buttons are available for the printer.

• Toggle button Start Print Position Check / Stop Print Position Check:

• Start Print Position Check - When you press this button, paper is forwarded to the stacker and the stacker automatically lowers. This allows you to check the printing status on the stacker table.

• Stop Print Position Check - When you press this button, the paper reverses to its original printing position.

		The Start / Stop Print Position Check procedure is:
1.	Set the printer to Not Ready.	Print line device background = yellow.
		Status window = yellow.
2.	Press the Start Print Position	Paper is forwarded to the stacker.
	Check button.	Print line device background = striped yellow/white.
		Status window = green.
		The stacker automatically lowers. The printer falls into error.
		Print line device background = striped red/white.
		Status window = red.
		You can now check the printing status on the stacker table.
3.	Press the Stacker Auto button.	The stacker raises.
4.	Press the RESET button to clear	Print line device background = striped yellow/white.
	the error.	Status window = yellow.
		Not Aligned displayed on the printer icon.
5.	Press the Stop Print Position	The paper reverses to its original printing position.
	Check button.	Print line device background = yellow.
		Status window = yellow.
6.	Set the printer to Ready.	Print line device background = green.
		Status window = green.

The following bubble menu command buttons are available, depending on the device configuration.

• Eject button - This button will only work for the device from which the eject is requested. This action will also take the printer out of alignment. Press the button for as long as you want the printer to eject paper. As the paper will only move in the selected device, there are risks of paper breaks. Always make sure there is enough paper available for the eject, or that the paper is cut. To do an eject for the whole line, you should use the eject button in the action bar on the screen.

• Release button - This button allows you to release paper to empty a whole part of the line. When you release paper, all devices downstream from the one that starts the release are in a state that allows them to move paper. Therefore, if you choose Release from the Unwinder bubble menu, all the paper in the print line will move.

Note: There exists the following limitation around the pre-processor in a release situation. It is possible to press the Release button when the pre-processor is off, Unwinder, for example. The problem is that

Page 4-12 Xerox 495 Continuous Feed Duplex Printer Operator Guide