Xerox 495 manual Code Display Message Procedure

ERROR CODESPROBLEM SOLVING

Code	Display Message		Procedure
16-11	Guide roller motor rotation alarm	A rotation error has been detected in the guide roller motor.
		1.	Check that Roller Unit A[R1a] is correctly installed and the
			thumbscrew is securely tightened (see "Replacing Roller unit
			A[R1a]" on page 8-13).
		2.	Press RESET on the touch screen and then set the printer to
			ready.
16-12	Fold-back motor rotation alarm	A rotation error has been detected in the fold-back motor.
		1.	Check that Roller Unit B[R1b] is correctly installed and the
			thumbscrew is securely tightened (see "Replacing Roller unit
			B[R1b]" on page 8-15).
		2.	Press RESET on the touch screen and then set the printer to
			ready.
16-13	Shield motor rotation alarm	A rotation error has been detected in the shield motor.
		1.	Check the printing status and the paper position.
		2.	Press RESET on the touch screen and then set the printer to
			ready.
16-16	Back tension motor rotation alarm	A rotation error has been detected in the back tension motor.
		1.	Check the printing status and the paper position.
		2.	Press RESET on the touch screen and then set the printer to
			ready.
19-4C	Transfer guide 1 position error	A position error has been detected in transfer guide A. It is not
	(attach)	attached.
		1.	Check the printing status and the paper position.
		2.	Press RESET on the touch screen and then set the printer to
			ready.
19-4D	Transfer guide 1 position error	A position error has been detected in transfer guide A. It is not
	(detach)	detached.
		1.	Check the printing status and the paper position.
		2.	Press RESET on the touch screen and then set the printer to
			ready.
19-7C	Transfer guide 2 position error	A position error has been detected in transfer guide B. It is not
	(attach)	attached.
		1.	Check the printing status and the paper position.
		2.	Press RESET on the touch screen and then set the printer to
			ready.
19-7D	Transfer guide 2 position error	A position error has been detected in transfer guide B. It is not
	(detach)	detached.
		1.	Check the printing status and the paper position.
		2.	Press RESET on the touch screen and then set the printer to
			ready.
1B-0B	Paper width motor time-out	1.	Press RESET on the touch screen.
		2.	Remove the paper jam (see "Clearing paper jams" on page 9-
			3).
		3.	Restart the autoload procedure (see "Paper autoloading" on
			page 5-4).
		4.	Press LOAD on the autoload panel.

Page 9-24 Xerox 495 Continuous Feed Duplex Printer Operator Guide