Xerox 495 manual Setting the perforation position, To set the paper position

PAPER PATH SETTING THE PERFORATION POSITION

Setting the perforation position

After a paper jam has been removed or if the paper position is changed with the Forward or Reverse switch, you will need to set the perforation position.

Note: This operation is not necessary at ordinary autoloading or during automatic switching mode (e.g. changing from simplex to duplex). The paper moves automatically to the correct position before starting to print.

To set the paper position:

1.Check the Perforation Number on the autoload panel.

2.Press Forward/Reverse on the autoload panel, to correct the paper alignment.

Tractor Cover

Scale

Perforation

3.Press the Fold-out/in switch so that the fold-out/in status of the perforation at Perforation Number matches the Fold-out/in lamp status.

Notes:

a.Even when the fold-out/in status of the perforation matches the Fold-out/in lamp status in, press the Fold-out/in Select switch.

b.The Perforation Number changes with the paper length but is not equal to the paper length value (inch). Be sure to check the Perforation Number when setting the perforation position.

The Perforation Number may change with the printing mode even when the paper length is the same.

c.If your paper is long and the perforation number becomes 13 or more, be sure to use the supplementary table.

Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 5-9