Xerox 495 manual Code Display Message Procedure

PROBLEM SOLVINGERROR CODES

Code	Display Message		Procedure
60-56	Developer 2 temperature alarm	1.	Record the displayed error code and message.
		2.	Press the RESET button to clear the error code.
		3.	Set the printer to ready.
		4.	If the problem persists, power the printer off then on.
		5.	If the problem persists, call for service or advice quoting the
			error code number and message.
60-57	Developer discharge lever [R2b]	At this point during the replacement of Developer [R2b], the dis-
	closed (emergency stop)	charge lever should be open.
		1.	Lift the lock lever of Developer [R2b] to unlock the discharge
			lever.
		2.	Pull the discharge lever out to open it.
		3.	Press RESET on the touch screen.
60-58	Developer discharge lever [R2b]	At this point during the replacement of Developer [R2b], the dis-
	open (emergency stop)	charge lever should be closed.
		1.	Push in the discharge lever of Developer [R2b].
		2.	Close the lock lever to secure the discharge lever.
		3.	Press RESET on the touch screen.
60-59	Developer discharge bottle [R2b]	At this point during the replacement of Developer [R2b], the dis-
	not set (emergency stop)	charge bottle should be set.
		1.	Open the empty bottle cover at the rear of the printer.
		2.	Remove the empty developer mixture bottle.
		3.	Set the empty bottle at developer discharge port [R2b].
		4.	Press RESET on the touch screen.
60-61	Developing unit 2 motor rotation	1.	Record the displayed error code and message.
	alarm	2.	Press the RESET button to clear the error code.
		3.	Set the printer to ready.
		4.	If the problem persists, power the printer off then on.
		5.	If the problem persists, call for service or advice quoting the
			error code number and message.
60-71	Developing unit 2 stirring axis rota-	1.	Record the displayed error code and message.
	tion alarm	2.	Press the RESET button to clear the error code.
		3.	Set the printer to ready.
		4.	If the problem persists, power the printer off then on.
		5.	If the problem persists, call for service or advice quoting the
			error code number and message.
60-72	Developer 2 magnetic roll rotation	1.	Record the displayed error code and message.
	alarm	2.	Press the RESET button to clear the error code.
		3.	Set the printer to ready.
		4.	If the problem persists, power the printer off then on.
		5.	If the problem persists, call for service or advice quoting the
			error code number and message.
62-24	Toner 1 density too high	1.	Record the displayed error code and message.
		2.	Press the RESET button to clear the error code.
		3.	Set the printer to ready.
		4.	If the problem persists, power the printer off then on.
		5.	If the problem persists, call for service or advice quoting the
			error code number and message.

Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 9-29