Xerox 495 manual Defining Production Jobs Defining a Paper Path

DEFINING PRODUCTION JOBS DEFINING A PAPER PATH

an existing Marks definition from the pull-down list.

A table showing details of the marks is shown on the screen.

•The X position is the distance from the edge of the paper nearest the front of the machine.

•The Y position is the distance from the leading edge of the paper.

•The W is the width of the mark measured from front to back of the machine. The maximum value is 18 inches (457.2mm).

•The H is the height of the mark in the paper movement direction. The maximum value is 18 inches (457.2 mm) or 14 inches (355.6 mm) if using the stacker.

•The columns identified by the side icons (front - and back-

marking units ) show the side for which the settings have been made (see "Front and back marking units" on page 2-2).

Note: If you specify the marks definition outside the printable area, you will fall into error. If you specify a value lower than 0.1mm, it defaults to 0mm.

3.Press the button to enter details of a new mark;

or highlight an entry in the table and press the button to modify an existing mark;

or highlight an entry in the table and press the button to delete an existing mark.

Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 7-25