Xerox 495 Name Function Effectiveness Forms Load, Cancel, Forms Length, Long, Short, One decimal

PRODUCT OVERVIEWOPERATOR PANELS

Name	Function	Effectiveness
Forms Load	Load	Effective when the printer is not
	Feeds paper automatically to the	operating. While the paper is auto-
	stacker table when pressed with	matically being loaded, the LED of
	paper set on the tractor. This func-	this switch remains lit.
	tion is called autoload.
	The main operator panel displays
	“Autoloading” If paper is set up to the
	stacker, the paper width is mea-
	sured. Then the main operator panel
	displays “Measuring paper width”.
	Cancel	Effective during autoloading.
	Press this switch to stop autoloading
	immediately.
Forms Length	Sets the length of the form in inches.	Effective when the printer is not
	The display will show the value	operating and has no paper inside.
	entered. Any changes made here
	will change the perforation number.
	Long
	Increments the units by 1 for each
	press of the button.
	Short
	Decrements the units by 1 for each
	press of the button
	One decimal
	Increments the decimal position by
	1/6 inch for each press of the button
Perforation number	Defines the position of the perfora-	Effective during autoloading.
	tion on the tractor scale.
Forms	Forward	Effective when the printer is not
	Feeds paper 1/6” (4.2mm) toward	operating
	the stacker.
	Holding down this switch feeds the
	paper continuously.
	Reverse	Effective when the printer is not
	Feeds paper 1/6” (4.2mm) toward	operating
	the hopper.
	Note: For complete data fusing,
	press this switch to align perforation.
	Note: If the forward / reverse button is pressed during a job (Data LED on),
	the printer considers that the operator wants to realign the position of the
	paper, and therefore discards data buffers and report a sense to the host.
	The host will then re-send the pages.
Fold-out/in select	Selects the swing guide direction.	Effective when the printer is not
	This switch is used to select fold-out/	operating
	in at perforation before autoloading
	and after a paper jam is removed
	and the paper length is aligned with
	the tractor scale.
	The corresponding lamp will indicate
	the setting.
RSV	Reserve switch

Xerox 495 Continuous Feed Duplex Printer Operator Guide Page 2-31