![](/images/new-backgrounds/1168125/168125383x1.webp)
ERROR CODESPROBLEM SOLVING
Code | Display Message |
| Procedure |
|
|
|
|
Developing unit 1 motor rotation | 1. | Record the displayed error code and message. | |
| alarm | 2. | Press the RESET button to clear the error code. |
|
| 3. | Set the printer to ready. |
|
| 4. | If the problem persists, power the printer off then on. |
|
| 5. | If the problem persists, call for service or advice quoting the |
|
|
| error code number and message. |
|
|
|
|
Developing unit 1 stirring axis rota- | 1. | Record the displayed error code and message. | |
| tion alarm | 2. | Press the RESET button to clear the error code. |
|
| 3. | Set the printer to ready. |
|
| 4. | If the problem persists, power the printer off then on. |
|
| 5. | If the problem persists, call for service or advice quoting the |
|
|
| error code number and message. |
|
|
|
|
Developer 1 magnetic roll rotation | 1. | Record the displayed error code and message. | |
| alarm | 2. | Press the RESET button to clear the error code. |
|
| 3. | Set the printer to ready. |
|
| 4. | If the problem persists, power the printer off then on. |
|
| 5. | If the problem persists, call for service or advice quoting the |
|
|
| error code number and message. |
|
|
| |
Developer discharge bottle [R2a] | At this point during the replacement of Developer [R2a], the dis- | ||
| not set (emergency stop) | charge bottle should be set. | |
|
| 1. | Open the empty bottle cover at the rear of the printer. |
|
| 2. | Remove the empty developer mixture bottle. |
|
| 3. | Place the empty bottle at developer discharge port [R2a]. |
|
| 4. | Press RESET on the touch screen. |
|
|
| |
Developer discharge lever [R2a] | At this point during the replacement of Developer [R2a], the dis- | ||
| closed (emergency stop) | charge lever should be open. | |
|
| 1. | Lift the lock lever of Developer [R2a] to unlock the discharge |
|
|
| lever. |
|
| 2. | Pull the discharge lever out to open it. |
|
| 3. | Press RESET on the touch screen. |
|
|
| |
Developer discharge lever [R2a] | At this point during the replacement of Developer [R2a], the dis- | ||
| open (emergency stop) | charge lever should be closed. | |
|
| 1. | Push in the discharge lever of Developer [R2a]. |
|
| 2. | Close the lock lever to secure the discharge lever. |
|
| 3. | Press RESET on the touch screen. |
|
|
| |
Developing unit interlock [R2a] | The interlock for developer unit [R2a] is not set. | ||
| (emergency stop) | 1. | |
|
|
| interlock. |
|
| 2. | Press RESET on the touch screen and then set the printer to |
|
|
| ready. |
|
|
| |
Developing unit interlock [R2b] | The interlock for developer unit [R2b] is not set. | ||
| (emergency stop) | 1. | |
|
|
| interlock. |
|
| 2. | Press RESET on the touch screen and then set the printer to |
|
|
| ready. |
|
|
|
|
|
|
|
Page | Xerox 495 Continuous Feed Duplex Printer Operator Guide |