Before you begin
The following steps should be completed before you configure the DocuColor and the workstations that will print to the DocuColor. A service technician will have performed some initial installation.
TO PREPARE FOR DOCUCOLOR INSTALLATION:
1.Print a copier test page to make sure the copier is functioning normally.
2.Turn off the copier and connect the interface cable from the copier to the DocuColor.
While the DocuColor is turned off, verify that the SCSI terminator is installed on the SCSI connector on the back of the DocuColor.
3.To confirm this connection, turn on the copier and the DocuColor and print a Test Page from the Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the Functions menu. (See “DocuColor Control Panel” on page
4.With both the copier and the DocuColor turned off, connect the network cable to the DocuColor, as described in the next section.
The network should already be installed and operational.
5.Turn on the copier and then the DocuColor.
6.Prepare network servers to share DocuColor user software and to enable networked users to print to the DocuColor, and proceed to Setup.
See Chapters 2 and 3 for details.
