Xerox 721P85600 manual Dry ink toner, Fuser agent, Developer, Tapes

PREINSTALLATION

Dry ink (toner)

Dry ink (also referred to as “toner”) is the black powder which forms the image on the printed page. There are three cartridges of dry ink in each container. Keep an adequate supply on hand at all times. The operator can change throw-away cartridges easily with no mess. Use only dry ink that is specified for use in your LPS. (Refer to the consumable supplies table at the end of the “Postinstallation” chapter.)

Fuser agent

Fuser agent is a consumable item required by the LPS. Keep an adequate supply on hand for installation by the Xerox or Xerox Limited service representative.

Developer

Developer is a required item that needs to be ordered and kept on hand. It is changed by a Xerox or Xerox Limited service representative. Use only developer specified for use in your LPS. (Refer to the consumable supplies table at the end of the “Postinstallation” chapter.)

Tapes

Each of the tape drives available on the DocuPrint 96/DocuPrint 96MX LPS requires a different tape format.

1/4-inch (QIC) The 1/4-inch QIC tape drive uses quarter-inch stream cartridge tapes. The tape data capacity should be 320 MB with 225 KB/second data transfer rate.

36-TRACKThe optional 18/36-track tape drive uses 0.5 inch cartridge tapes with a data capacity of 1.2 GB.

18-TRACKThe optional 18/36-track tape drive also uses 0.5-inch IBM 3480- compatible cartridge tapes with a data capacity of 200 MB. Cartridges are not available from Xerox.

9-TRACKThe optional 9-track tape drive supports reel-to-reel 9-track 1600 bpi (PE) and 6250 bpi (GCR) encoded magnetic tapes.

3-28 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS INSTALLATION PLANNING GUIDE