Zebra Technologies TTP 2000 Parameters Used, Parameter n36 — Document Mode, Parameter n39 — Max Black Mark Length, Parameters n37 and n38 — Page Length Minimum

104Page setup Parameters Used

Parameters Used

Parameter n36 — Document Mode

1.Set to 2 to enable black mark check.

Parameters n37 and n38 — Page Length Minimum

1.Measure the distance from the trailing edge of one black mark to the trailing edge of the next. The resolution is 0.125 mm so multiply the distance by 8, then calculate the value to enter as n37 and n38.

Example • If the page length is 100mm, (100 x 8) / 256 = 3.125.

n37 is the integer value, that is 3, while

n38 is the fraction, 0.125 x 256 = 32

Parameter n39 — Max Black Mark Length

1.Measure the height of the black mark. The resolution is 0.125 mm so multiply the black mark length (in millimeters) by 8 and enter the value as n39.

Parameter n40 — Min Black Mark Length (Garbage Filter)

This parameter is actually a filter to filter-out garbage on the paper. If a spot is smaller than this value, it will not be regarded as a black mark.

About 1/3 of the black mark length is usually a suitable setting.

P1002902-002 TTP 2000 Technical Manual 09/14/2009