106Page setup Parameters Used

Parameter n41 and n42 — Black Mark Cut Offset

After the black mark is detected (black to white change) the printer feeds another distance to place the paper in cut position. This distance cannot be negative so placing the black mark too close to the paper edge is better than too far away.

Auto Cut-Offset

If the offset is set to 0, the printer will measure the length of the black mark and add a cut offset that makes it cut in the middle of the black mark.

Cut position

n41 & n42=0

Black mark detected

Note • Auto offset was added in firmware version 3.30.

P1002902-002

TTP 2000 Technical Manual

09/14/2009