Programming 53

Software Command Syntax

ESC g n1...n5

 

Print Logotype

1B 67

n1...n5

hex

27 103

n1...n5

decimal

 

Prints a customized logotype stored in the flash PROM. See also Logotypes on page 74.

n1

One-byte logotype identification number. The valid range is 0 to 15.

 

 

n2n3

Two byte definition of the X print position to place the upper left corner of the

 

logotype (in pixels). If the logotype extends outside the printable area, it will

 

be clipped.

 

 

n4n5

Two byte definition of the Y print position to place the upper left corner of the

 

logotype (in pixels). If the logotype extends outside the printable area, it will

 

be clipped.

 

 

Note • The Y print position and horizontal/vertical orientation only works if Fixed

Document Mode is set. Refer to Document Mode on page 89 for more information.

 

 

 

Note • For information about logotype loading, refer to ESC & 1 on page 59.

 

 

 

ESC L n1

 

Print Logotype at Current Position

1B

4C n1

Hex

 

27

76 n1

Decimal

 

 

 

 

 

Prints a customized logotype stored in the flash PROM at the position of the cursor. The

 

 

 

bottom edge of the logotype is positioned at the baseline of the text on the line. If the logotype

 

 

 

is taller than the text, the line spacing is increased as necessary.

 

 

 

 

 

 

 

 

n1

One-byte logotype identification number. The valid range is 0 to 15.

 

 

 

 

 

Note • When using ESC L, the logotype is added to the text buffer, so a text printing command such as LF or FF must be used to generate the printout.

09/14/2009

TTP 2000 Technical Manual

P1002902-002