96Default Parameter Settings Print Setup

57

255

Default

System

DRV

0

Min

 

255

Max

 

 

The system parameter will control up to eight system components in the printer.

The bits specified so far are these:

Bit 0

Clear presenter at reset

 

 

Bit 1

Pull detector

 

 

Bit 2

Horizontal

 

 

Bit 3

Standard BM

 

Note • This parameter is set automatically when you run the

 

“Calibrating the TOF sensor procedure” (manually or using ESC #).

 

 

Bit 4

Disable USB reconnect

 

Note • If reconnect is enabled, the PC will not be able to go to sleep

 

mode.

 

 

Setting a bit to 1 enables the function and setting it to 0 disables it.

Important • If the function of a bit is not specified, it must always be set to 1.

Example •

<ESC>&P<57><254> Presenter will not be cleared at power ON and reset <ESC>&P<57><253> The pull detector is disabled

<ESC>&P<57><252> The presenter will not be cleared at power ON and reset and the pull detector is disabled

<ESC>&P<57><251> The printer is set to vertical mode, that is the retract output and the normal output are swapped.

<ESC>&P<57><239> The printer will monitor USB heartbeat (SOF tokens), and thus try to reconnect if they disappear.

<ESC>&P<57><255> The printer is reset to normal behavior

58

0

Default

Out-of-Paper Level

0

Min

 

255

Max

 

Sets the level at which the TOF sensor detects out of paper. The out-of-paper level may differ from the black-mark level on label stock where the foil opacity indicates top of form.

This parameter is set automatically when you run the “Calibrating the TOF sensor procedure” (manually or using ESC #).

P1002902-002

TTP 2000 Technical Manual

09/14/2009