Operation 31
Installing a Paper Roll
4.Cut the paper at a suitable angle. See Figure 20.
Figure 20 • Suitable Paper Edge for Auto Load
Cut off at
a
90º
Thermal side (top)
Important • The paper sensor for 58 mm and 60 mm paper is at the same side as the interface connector, while the sensor for 80 mm and 82.5 mm paper is on the power connector side. If the paper is cut in a direction opposite to that as shown in the figure above, the sensor will not detect the paper.
5.Insert the paper through the paper entry opening at the back of the printer.
The printer will now feed, cut and eject a printout, and then automatically go
Figure 21 • Insert the New Paper
09/14/2009 | TTP 2000 Technical Manual |