Zebra Technologies TTP 2000 Design Your Own Mounting

20Installation

Using a Zebra Roll Holder

Design Your Own Mounting

The illustration below gives an example of a printer-mounting shelf. See Figure 33, Printer Dimensions (Measurements), on page 125, and the 3D solid models and outline drawings for CAD that are available on http://www.zebra.com.

Figure 8 • Example of a Simple Shelf For Fastening a Standard Printer Using

Quick-fit Hubs and a Leaf Spring Retainer (Order No. 01473-000)

		m
	m
.5
1

Leaf spring 01473-000

	156 mm
	132 mm
	90.8 mm
	10 mm	10 mm
Min.100 mm		mm	mm
	Paperwidth 10+ mm	∅6.5	∅12
			Center
			10 mm
		10 mm	∅11 mm

20 mm 44 mm

Add material for corner radius

Additional space is required for paper loading and paper jam removal. Consider mounting the printer on a movable platform so that the printer can be maintained outside the printer enclosure.

Note • The paper entry angle must be set properly to avoid paper jams in the presenter. Refer to Paper on page 121 for the specification.

Caution • NEVER use screws that go into the printer more than 4 mm! This will damage the electronics inside.

P1002902-002 TTP 2000 Technical Manual 09/14/2009