94Default Parameter Settings Print Setup
48 | 0 | Default | Paper Width (mm) | DRV |
0 & 20 | Min | |||
| 80 | Max |
|
|
Sets the width of the paper loaded into the printer. The range is 20 to 80 mm. This can also be used to get left and right margins, for instance if you load 80 paper but set the paper width to 60 mm you get a 10 mm margin on both sides of the page.
Note • The page width is not changed until the parameters are stored in the EEPROM with the command <ESC>&<4>. So you cannot change paper width within a page.
| . |
|
|
<ESC>&P<48><0><ESC>&<4> | Sets width detection by sensor (54 or 72 mm) |
<ESC>&P<48><60><ESC>&<4> | Sets 60 mm print width |
Note • It is recommended that a print width narrower than the actual paper loaded in the printer is used to ensure that the print always remains visible.
49 | 1 | Default | Advance Before Cut | DRV |
0 | Min | |||
| 1 | Max |
|
|
Selects if the cut command cuts at the position where the paper is at, or if the printer should advance the paper before cutting.
<ESC>&P<49><0> | Off |
<ESC>&P<49><1> | Automatic Distance Calculation |
Note • "Automatic Distance Calculation" means advancing the paper with the
Set to 1 if the printer is used in text mode and 0 if it is used from a driver that takes care of this in the driver.
Note • The paper is advanced before the FF command calculates the page length to see if the page length is longer than the set minimum length.
51 | 75 | Default | Black Mark Sensitivity |
0 | Min | ||
| 255 | Max |
|
This parameter is set automatically when you run the “Caibrating the TOF sensor procedure” (manually or using ESC #). Normally there is no need to set this parameter manually.
0 is white and 255 is pitch black (out of paper).
TTP 2000 Technical Manual | 09/14/2009 |