108Page setup
ESC Z (Go To Next Top of Form)
Use ESC Z to move the paper to the next top of form. This is practically a
The commands are used together in the following way:
The following examples are not made for a specific programming language or editor, but can be implemented with the tools of your choice.
When setting up the printer, sending the command listed provides the result that follows.
<ESC>&P<36><2> enables black mark sync.
<ESC>&P<37><4>
<ESC>&P<38><0> Sets distance between two black marks. The values in the example give 128 mm.
<ESC>&P<39><80> Sets max Black mark to 80 x 0.125 = 10mm.
<ESC>&P<40><24> Sets max Black mark to 24 x 0.125 = 3 mm.
<ESC>&P<41><0>
<ESC>&P<42><200> Sets Black mark offset to 200 x 0.125 = 25mm.
<ESC>&P<43><0>
<ESC>&P<44><0> Sets Black mark top margin to 0mm.
<ESC>&<4> Stores the above parameters as default parameters.
The above setup and stores the parameters in the EEPROM of the printer, so this needs only be sent once to the printer when setting it up for Black mark sync.
•For the document, send the text and graphics.
•At the end of the document:
Send This Command… | For This Result |
|
|
<ESC>Z | Feeds the printout to the next |
| additional feed specified by the <ESC>x command. |
<RS> | Cuts and ejects the printout. |
Black-Mark Sensing from within Windows
Refer to the Driver Reference Guide, Part Number
www.zebra.com for detailed information about
TTP 2000 Technical Manual | 09/14/2009 |