Installation 17
Installation Considerations
Installation Considerations
The TTP 2000 printer is designed to be installed in an enclosure such as a
Caution • NEVER use screws that go into the printer more than 4 mm! Longer screws will damage the electronics inside.
Orientation
The TTP 2000 can be installed horizontally or vertically. Vertical installation is suitable for narrow kiosk designs. The printer can be programmed to present the receipt from either of the two output paths, retract and standard. The standard output becomes the retract, and the retract output feeds the printout to the customer.
The printer can be installed in different orientations. Set parameter n57 to the appropriate setting and the printer adapts to its new orientation. Refer to System on page 96 for more information.
Figure 5 • Orientation Options for Installation
Horizontal | Vertical |
Screen | Screen |
Note • In vertical mode the printer does not loop the paper but stores it hanging down, then cuts and ejects vertically when the printout is ready.
09/14/2009 | TTP 2000 Technical Manual |