Default Parameter Settings |
| 93 |
| ||
Print Setup |
|
|
46 | 0 | Default | Cut Position Calibration |
0 | Min | ||
| 255 | Max |
|
Calibrates the cut position. The value is a signed byte.
A change of 1 moves the cut 1/8 of a mm more than normal.
A change of
The positive range is
This parameter can be individually set for each printer and is not affected by the driver or reset commands. It is used to compensate for differences in sensor position in production. After moving or replacing the
<ESC>&P<46><0> | The cut is placed at the center of the sensor’s image of the |
| |
|
|
<ESC>&P<46><8> | The paper is fed 1 mm extra before being cut. |
<ESC>&P<46><248> | The paper is fed 1 mm less before being cut. |
Note • The cut is not 100% repetitive because the paper may be closer to the sensor for one ticket than it is for the next. So do not expect a perfect synchronization between perforation and cut.
It is better to cut slightly after a perforation than before because cutting before perforation leaves a flap that is pushed through the printer and that may cause paper jam.
47 | 0 | Default | Wall Compensation (mm) | DRV |
0 | Min | |||
| 255 | Max |
|
|
When the printout is printed and cut, the presenter ejects 50 mm of the page so that the customer can take it. If the kiosk wall is thick, or if you just want a longer part of the printout to be visible, this parameter adds extra eject length.
n47
Eject n
Printer Kiosk
wall
<ESC>&P<47><50> | Adds 50 mm extra eject = 100 mm in total. |
09/14/2009 | TTP 2000 Technical Manual |