Appendix

Troubleshooting

If there are problems during operation of the MRS-802,

check the following points first.

■The indication "STOP RECORDER" is shown on the display, and operation is not possible.

The current operation is not possible while the recorder is operating. Press the STOP [P] key to stop the recorder.

Problems during playback■No sound, or sound is very weak

•Check the connections to your audio system, and the volume of your audio system.

•Make sure that the status keys in the mixer section are lit in green and that the faders are raised. If a key is out, press the it to make it light up in green.

•If a scene with the volume lowered has been assigned to a mark, the volume will automatically be lowered when that

mark is reached. Delete the scene that is assigned to the mark (→ p. 76).

•The recorder will not operate when the [DRUM] key is lit. Press the [EXIT] key so that the [DRUM] key goes out.

■Operating the fader does not affect the volume

•On channels for which stereo link is turned on, the fader

of the even-numbered channel will have no effect. Either turn stereo link off (→ p. 73), or operate the fader of the

odd-numbered channel.

■The display indicates "Don't Play" and playback is not possible

•The recorder will not operate in the current screen. Press the [EXIT] key several times to switch to the main screen.

■No sound from input signal, or sound is very weak

•Make sure that the [INPUT 1]/[INPUT 2] key is lit.

•Make sure that the respective [INPUT] control is raised.

•Make sure that the [REC LEVEL] control is raised. If it is raised, temporarily turn it down and then up again.

Problems during recording■Cannot record on a track

•Make sure that you have selected a recording track.

•Check whether you have run out of free space on the hard disk (→ p. 125).

•Recording is not possible if the project is write-protected. Either turn protect off (→ p. 127), or use a different

project.

■The signal from an instrument or microphone connected to the INPUT 1 jack is not input

•When something is connected to both the INPUT 1 jack and the GUITAR/BASS jack, the GUITAR/BASS jack has priority.

■The recorded sound is distorted

•Check whether the input sensitivity setting ([INPUT control) and recording level setting ([REC LEVEL] control) are appropriate.

•Lower the fader so that the 0 (dB) dot of the level meter does not light.

•If the EQ gain of the track mixer is set extremely high, the sound may be audibly distorted even if the fader is lowered. Set the EQ to an appropriate value.

Problems with effects■Insert effect does not apply

•Make sure that the [BYPASS/TUNER] key is out.

•Make sure that the insert effect is sent to the desired location (→ p.101).

■Send/return effect does not apply

•Make sure that the [CHORUS/DELAY] or [REVERB] key is lit. If it is out, press the key several times to make it light.

ZOOM MRS-802

142