Reference [Track Editing]

The indication “Move SURE?” appears on the display.

8. To execute the move operation, press the [ENTER]

key.

By using the [EXIT] key instead of the [ENTER] key, you can move back to previous screens.

When the move is executed, the indication “Move COMPLETE” appears on the display, and the unit returns to the track edit menu.

Erasing a specified range of data

You can erase the audio data of a specified range and return the range to the mute (non-recorded) condition.

Erase

1. Refer to steps 1 - 6 of “Basic editing steps” to select the track/V-take for erasing, and press the [ENTER] key.

The display changes as follows. This screen lets you specify

the erase range start point.

Ers Src 00

START

0 0 0 0 001 1 0

2. Use the cursor left/right keys to move the flashing section of the counter, and turn the dial to specify the erase start point.

You can also specify the point as a mark.

3. Press the [ENTER] key.

The display changes to “Ers Src END”.

Ers Src 00

END

0 132 0 042 124

4. Use the same procedure as in step 2 to specify the erase range end point.

If you press the PLAY [R] key at this point, the specified

range will be played.

ZOOM MRS-802

5. Press the [ENTER] key.

The indication “Erase SURE?” appears on the display.

6. To execute the erase operation, press the [ENTER]

key.

By using the [EXIT] key instead of the [ENTER] key, you can move back to previous screens.

When the erase is executed, the indication “Erase COMPLETE” appears on the display, and the unit returns to the track edit menu.

Trimming a specified range of data

You can erase the audio data of a specified range and adjust the data start/end point (trimming). For example, when preparing to burn the master track onto a CD-R/RW disc, you might want to remove unwanted portions at the start and the end of the V-take that will be used.

EraseErase

NOTE

When data before a specified section are erased (trimmed), the remaining audio data will move up by that amount. Therefore the timing may become mismatched with regard to other tracks/V-takes.

1. Refer to steps 1 - 6 of “Basic editing steps” to select the track/V-take for trimming, and press the [ENTER] key.

The display changes as follows. This screen lets you specify the start point for the range to be preserved after trimming (all data before this point will be erased).

Trim Src 00

START

0 0 0 0 001 1 0

2. Use the cursor left/right keys to move the flashing section of the counter, and turn the dial to specify the range start point.

You can also specify the point as a mark.

3. Press the [ENTER] key.

49