Reference [Other Functions]

Init ALL

Sure?

2. To carry out the initialization process, press the

[ENTER] key once more.

The all initialize process starts. When it is complete, the unit returns to the condition of step 1.

Hard disk maintenance using supplied CD-ROM

Certain hard disk maintenance functions can be performed using the CD-ROM supplied with the MRS-802.

■Restoring the unit to the factory default condition (RECOVER)

This action restores the entire hard disk of the MRS-802 (including the demo songs) to the factory default condition. All data created by the user will be erased.

■Factory initialize (VER UP)

This action restores the system files and other data necessary for operation of the MRS-802.

1. With the supplied CD-ROM inserted in the CD-R/ RW drive, turn the MRS-802 on by pressing the [POWER] switch on the rear panel.

2. Use the cursor left/right keys to select “RECOVER?” (to return the unit to the factory default condition) or “VER UP” (to perform factory initialize) and press the [ENTER] key.

The indication “Sure?” appears for confirmation of the action. If you wish to cancel the action, press the [EXIT] key. When the indication “Please PowerOff” is shown, set the [POWER] switch to OFF to turn the unit off.

3. To carry out the action, press the [ENTER] key

once more.

The maintenance process starts. When it is complete, the indication “Done” is shown. Remove the CD-ROM from the drive and turn the unit off and on again.

ZOOM MRS-802

Connecting to a computer with an option card

If the optional USB board UIB-01/UIB-02 is installed in the MRS-802, the internal hard disk of the MRS-802 can be recognized by a computer, for audio data editing, project backup etc. To make this possible, connect the computer and MRS-802 with a USB cable and start the MRS-802 in USB mode.

HINT

Depending on the computer and the operating system, driver installation may be required. For details, see the on-line manual supplied with the UIB-01/UIB-02.

1. Verify that power to the MRS-802 is turned off. Then connect the option board to the computer with a USB cable.

2. While holding down the [CLEAR] key in the control section, turn power to the MRS-802 on.

The following screen appears on the display.

ROM UTY

MRS-802

3. Press the [AUTO PUNCH IN/OUT] key in the control section.

The following screen appears on the display, and the MRS- 802 switches to USB mode.

I/FWORKING

When USB is activated, the computer automatically recognizes the internal hard disk of the MRS-802 and goes into the on-line state.

For details on operation, see the on-line manual supplied with the UIB-01/UIB-02.

139