Zoom MRS-802 3Ba, COMP, TOTAL, TOTAL, TOTAL, TOTAL, TOTAL, DEPTH, EQ Lch, PRE/DRV, MOD/DLY, MIC PRE, MOD/DLY, MOD/DLY, NORMLZR, FLANGER, MOD/DLY, FLANGER, MicPre L, DLY

Reference [Effects]

Algorithm			Module/Display
CLEAN	COMP	PRE/DRV	3BandEQ	MOD/DLY	TOTAL
DIST
ACO/BASS SIM	COMP	PRE AMP/DRIVE	EQ	MODULATION/DELAY	ZNR, VOL PDL, PAT LVL
BASS
MIC	COMP/LIM	MIC PRE	3BandEQ	MOD/DLY	TOTAL
	COMP/LIM	MICPRE+DE-ESSER	EQ	MODULATION/DELAY	ZNR, VOL PDL, PAT LVL
DUAL MIC	COMP Lch	MicPre L	EQ Lch	DOUBLE L	TOTAL
	COMP/LIM	MICPRE	EQ	DOUBLING	ZNR, VOL PDL, PAT LVL
LINE	COMP/LIM	ISOLATOR	3BandEQ	MOD/DLY	TOTAL
	COMP/LIM	ISOLATOR	EQ	MODULATION/DELAY	ZNR, VOL PDL, PAT LVL
	CMP/LoFi	NORMLZR	3BandEQ	DIM/RESO	TOTAL
MASTERING
	3BAND COMP/	NORMALIZER	EQ	DIMENSION/	ZNR, VOL PDL, PAT LVL
	Lo-Fi			RESONANCE

NOTE

The table above shows the condition when the effect module is On. When the effect module is Off, the second line of the display shows “-OFF-”.

FLANGER

DEPTH 2

Setting value

4. If you want to switch the effect type for theselected module, turn the dial to select the desiredeffect type.

MOD/DLY

FLANGER

Effect type name

HINT

6. Turn the dial to change the setting.

For details on the effect types that can be selected for each effect module, and on the effect parameters of each type, refer to the appendix (→ p. 145 – 153) at the end of this manual.

7. To switch the module On/Off setting, bring themodule onto the display and press the [ENTER]

key.

•If the contents of a patch have been edited, the “EDIT” indicator in the upper part of the display will change to “EDITED”.

•If “TOTAL” is shown on the display, you can use the cursor up/down keys to select PAT LVL, ZNR, or VOL PDL.

NOTE

Some effect modules have only one effect type. For such modules, there will be no screen for selecting the effect type.

5. Use the cursor up/down keys to select the effectparameter that you want to edit.

When you use the cursor up/down keys, a setting screen for the effect types and parameters for this module is shown. The following diagram shows an example of what appears on the display when you have selected the DEPTH parameter of the “FLANGER” effect.

When the effect module has been set to Off, the effect type name is shown as “-OFF-” on the display. If you press the [ENTER] key once more in this condition, the setting is returned to On.

FLANGER -OFF-

NOTE

If “TOTAL” is shown on the first line of the display, you can adjust the ZNR/VOL PDL module setting and the patch level. Switching the effect module On/Off is not possible in this case.

8. Repeat steps 3 - 7 to make the desired edits forother modules.

ZOOM MRS-802

104