Zoom MRS-802 Permissn, AllFader ON, • REVERB group, • CHORUS/DELAY group, • INSERT EFFECT group, • TRACK PARAMETER group, Deleting certain parameters from a scene

Reference [Mixer]

HINT

To cancel a scene assignment, turn the dial to make the

display indicate “ -- “.

6. Locate the next mark at which you want the mix to change, and repeat steps 4 - 5.

7. When scenes have been assigned to all marks, press the ZERO [U] key to return to the beginning of the song, and then press the PLAY [R] key to start playback.

Each time the song reaches a mark to which a scene has been

assigned, that scene will be recalled.

Deleting certain parameters from a scene

If desired, you can disable a group of parameters saved in a scene. Such parameters will not change even if that scene is recalled. The following groups of parameters can be specified and made active or inactive.

Group	Item
	EQ HI
	EQ LO
TRACK
	Chorus send
PARAMETER
	Reverb send
	Pan
	Play/mute
INSERT EFFECT	Patch number
	Input source
CHORUS/DELAY	Patch number
REVERB	Patch number
ALL FADER	Fader position

For example, after you have programmed a sequence of automatic scene changes, you may want to disable the TRACK PARAMETER group and set only the EQ and panning parameters manually for each track.

1. Press the [SCENE] key in the control section, andthen press the [UTILITY] key in the display section.

The following screen appears on the display. In this

condition, you can enable or disable the faders for each

scene.

PermissnAllFader ON2. Turn the dial to set fader permission to ON or OFF.3. Press the other keys for parameter groups, to enable or disable the group.

Except for the fader, scene control for the other groups can be enabled or disabled by pressing one of the keys listed below.

• TRACK PARAMETER group

Any status key except [MASTER] status key

• INSERT EFFECT group

Any [INSERT EFFECT] key

• CHORUS/DELAY group

[CHORUS/DELAY] key

• REVERB group

[REVERB] key

When a group is enabled, the respective keys are lit, and when the group is disabled, the keys are flashing.

HINT

•The TRACK PARAMETER group can be enabled or disabled for each audio track and the drum track separately.

•You can also use the cursor up/down keys to enable or disable all groups together.

4. When the setting is complete, press the [EXIT] key.

The unit returns to the scene menu.

5. To return to the main screen, press the [EXIT] key.

The parameter group on/off status is stored as part of the

project.

ZOOM MRS-802

76