Reference [Creating a CD]

is finished, the display indication changes to “ALL SAVE

COMPLETE”.

NOTE

When a full backup spans several discs, restoring a single project requires you to first insert the disc on which it is saved. Be sure to note the disc number and the projects saved on the disc on the case and label of the disc.

HINT

When the disc has been ejected, it also possible to abort the backup operation. To do this, press the [EXIT] key while the indication “CHANGE DISCxxx” (where xxx is the disc number) is shown. The indication will change to “ALL SAVE CANCEL?”. Press the [ENTER] key to terminate the process.

8. To return to the main screen, press the [EXIT] key

several times.

Loading a project from CD-R/RW disc

To restore a project saved on CD-R/RW disc to the hard disk

of the MRS-802, proceed as follows.

1. From the main screen, press the [CD-R/RW] key in the display section.

The CD-R/RW menu appears.

2. Use the cursor left/right keys to bring up the indication “CD-R/RW BACKUP” on the display, and press the [ENTER] key.

The display shows the backup/restore menu.

BACKUP

SAVE

3. Use the cursor left/right keys to bring up the indication “BACKUP LOAD” on the display, and press the [ENTER] key.

The indication “LOAD InsDisc1” appears on the display.

LOADInsDisc1
4. Insert the CD-R or CD-RW where the project is saved into the CD-R/RW drive.• If project was backed up as single project

Insert disc number 1.

•If project was backed up as part of a full backup of all projects

Insert the disc where the project is stored. (If there are multiple discs, insert the first disc that contains data of the desired project.)

NOTE

•Also when you have backed up all projects in a single operation, restore is performed for single projects.

•If the backup of the project spans multiple discs, be sure to insert the first disc that contains data of the desired project first. If you insert another disc, the project data will not be read correctly.

5. Press the [ENTER] key.

The name of the project on the disc, and the number which is to be assigned to the project are shown on the display.

LOAD

PRJ012 7

Project name Project number to be assigned

HINT

When being restored to the MRS-802, an empty project number is automatically assigned to the project. Even if a project with the same name already exists on the hard disk, it will not be overwritten.

6. To check the name of the directory from which theproject will be read, press the cursor down button.

The display shows the directory name.

DirName

PROJ012 7

Directory name

Press the cursor up key to restore the original display.

ZOOM MRS-802

122