Table 34 Classifier (continued)
LABEL DESCRIPTION
Layer 2
Specify the fields below to configure a
VLAN | Select Any to classify traffic from any VLAN or select the second option and specify |
| the source VLAN ID in the field provided. |
|
|
Priority | Select Any to classify traffic from any priority level or select MAC and specify a priority |
| level in the field provided. |
Ethernet Type | Select an Ethernet type or select Other and enter the Ethernet type number in |
| hexadecimal value. Refer to Table 36 on page 125 for information. |
| Select All if you don’t know. |
|
|
Source |
|
|
|
MAC Address | Select Any to apply the rule to all MAC addresses. |
| To specify a source, select MAC and type a MAC address in valid MAC address format |
| (six hexadecimal character pairs). |
Port | Select the port to which the rule should be applied. You may choose one port only or all |
| ports (All Ports). |
Destination |
|
|
|
MAC Address | Select Any to apply the rule to all MAC addresses. |
| To specify a destination, select the second choice and type a MAC address in valid |
| MAC address format (six hexadecimal character pairs). |
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP | Select Any to classify traffic from any DSCP or select the second option and specify a |
| DSCP (DiffServ Code Point) number between 0 and 63 in the field provided. |
|
|
IP Protocol | Select an IP protocol type or select Other and enter the protocol number in decimal |
| value. Refer to Table 37 on page 126 for more information. |
| You may select Establish Only for TCP protocol type. This means that the switch will |
| pick out the packets that are sent to establish TCP connections. |
Source |
|
|
|
IP Address/ | Enter a source IP address in dotted decimal notation. |
Address Prefix | Specify the address prefix by entering the number of ones in the subnet mask. |
|
|
Socket | Note: You must select either UDP or TCP in the IP Protocol field |
Number | before you configure the socket numbers. |
| Select Any to apply the rule to all TCP/UDP protocol port numbers or select the |
| second option and enter a TCP/UDP protocol port number. |
|
|
Destination |
|
|
|
IP Address/ | Enter a destination IP address in dotted decimal notation. |
Address Prefix | Specify the address prefix by entering the number of ones in the subnet mask. |
|
|
Socket | Note: You must select either UDP or TCP in the IP Protocol field |
Number | before you configure the socket numbers. |
| Select Any to apply the rule to all TCP/UDP protocol port numbers or select the |
| second option and enter a TCP/UDP protocol port number. |
|
|
Add | Click Add to save the changes. |
|
|
Chapter 18 Classifier | 124 |