GS-4012F/4024 User’s Guide

41.8.1 interface port-channel

Syntax:

interface port-channel <port-list>

Use this command to enable the specified ports for configuration. Type multiple ports or port ranges separated by a comma. Ranges of port numbers are typed separated by a dash.

An example is shown next.

•Enter the configuration mode.

•Enable ports one, three, four and five for configuration.

•Begin configuring for those ports.

Figure 178 interface Command Example

ras# config

ras(config)# interface port-channel 1,3-5 ras(config-interface)#

41.8.2 interface route-domain

Syntax:

interface route-domain <ip-address>/<mask-bits>

where

<ip-address>= This is the IP address of the switch in the routing domain. Specify the IP address is dotted decimal notation. For example, 192.168.1.1.

<mask-bits>= The number of bits in the subnet mask. Enter the subnet mask number preceded with a “/”. To find the bit number, convert the subnet mask to binary and add all of the 1’s together. Take “255.255.255.0” for example. 255 converts to eight 1’s in binary. There are three 255’s, so add three eights together and you get the bit number (24).

Use this command to enable/create the specified routing domain for configuration.

An example is shown next.

•Enter the configuration mode.

•Enable default routing domain (the 192.168.1.1 subnet) for configuration.

•Begin configuring for this domain.

279

Chapter 41 Command Examples