GS-4012F/4024 User’s Guide

3Choose a location to save the file on your computer from the Save in drop-down list box and type a descriptive name for it in the File name list box. Click Save to save the configuration file to your computer.

32.5Load Factory Defaults

Follow the steps below to reset the switch back to the factory defaults.

1In the Maintenance screen, click the Click Here button next to Load Factory Defaults to clear all switch configuration information you configured and return to the factory defaults. The following message appears.

Figure 120 Load Factory Default: Conformation

2Click OK to display the screen shown next.

Figure 121 Load Factory Default: Start

3Click OK to begin resetting all switch configurations to the factory defaults and then wait for the switch to restart. This takes up to two minutes. If you want to access the switch web configurator again, you may need to change the IP address of your computer to be in the same subnet as that of the default switch IP address (192.168.1.1).

32.6Reboot System

Reboot System allows you to restart the switch without physically turning the power off. Follow the steps below to reboot the switch.

1In the Maintenance screen, click the Click Here button next to Reboot System to display the next screen.

Figure 122 Reboot System: Confirmation

2Click OK to display the screen shown next.

Chapter 32 Maintenance

202